What are the structural components of DC Blower?

The DC Blower is made of alloy material and can be used more than 50,000 hours continuously. The internal DC structure has a transformer and main control board (including frequency conversion circuit, rectifier filter, amplifier circuit, etc.), which are not affected by voltage fluctuations, so that their service life is longer.

What should we pay attention to when using DC Blower?

What are the institutional features of DC Blower?

What are the structural components of DC Blower?

What should we pay attention to when using DC Blower?

1. Strengthen operation management and prohibit illegal operation. There should be strict operational specifications for the start-up and operation of DC blowers. If you need to start the suction fan without load, it is strictly prohibited to start with load. If the start time is too long, the blower motor will easily overheat and will cause overload and burn up.

2. Reinforced surface, improve the wear resistance of the blade. Most commonly, DC blower dropout, vibration and blade breakage and other accidents occur. Therefore, the working surface of the blade or wear serious parts should be covered, in order to improve the wear resistance of the blade. Practice has proved that the blade by the surface treatment, its wear resistance greatly improved, not only changed the impeller fan frequent wear situation, but also for the safe operation of the fan laid a good foundation.

What are the institutional features of DC Blower?

1. Since the impeller of DC blower runs frictionlessly in the casing, it does not need lubrication and the discharged gas does not contain oil. It is the ideal gas source for chemical, food and other industries Shanghai DC blower.

2. The structure of DC blower determines its mechanical friction loss is very small. Since only the bearing and gear pairs are in mechanical contact with the selected material, the rotor, housing and tooth ring have sufficient mechanical strength. Safe operation and long service life are the main features of the blower products.

3.The rotor of the DC blower has been tested for static and dynamic balance. The finished product runs quietly with low vibration.

What are the structural components of DC Blower?

Rotor. It consists of shaft, impeller, bearing, synchronous gear, clutch, bushing, etc.

Synchronous gear box. It consists of a gear ring and a hub, with which the wheel clearance can be easily adjusted.

Body: It consists of a housing and left and right wall plates. The left and right wall plates and the bearing housing and sealing parts mounted on the left and right wall plates can be used together.

Chassis. Medium and small fans are equipped with a common base, while large fans are equipped with only one fan base for easy installation and commissioning.

Lubrication. Gears are lubricated by immersion type and bearings are lubricated by spray type. Well lubricated, safe and reliable.

Dongguan Xingdong Electronics Co., Ltd. is always focused on customers’ needs, therefore providing the best DC Blowers for all customers from all over the world. If you want to know more, please connect them.